Early edition: some topics are still in progress. Every fact links to an official source.
Stay-Go Guide

Home / Topics / Water

Water · How-to

Water filters, tablets, and other ways to treat water

What each method can and cannot do, according to CDC, EPA, and Ready.gov.

Safety numbers are quoted, not invented. Every dose, time, temperature, and ratio on this page is copied from the agency named beside it. Where agencies differ, we show each one with its source instead of picking. If your local health department or officials give different instructions, follow them.

Boiling and bleach are the first choices. These other methods are useful backups, and some work best in combination. Ready.gov notes that often the best solution is a combination of methods.[1]

At a glance

Summary of official guidance (Ready.gov method table; CDC notes)
MethodKills germs?Removes chemicals, metals, salts?Notes
Boiling[1]YesNoCDC: best way to kill germs
Chlorination (bleach)YesNoLess effective on Giardia and Cryptosporidium (CDC)
DistillationYesYes (heavy metals, salts, most other chemicals)Slow; uses fuel
Portable filter[2]Depends on pore size; will not remove virusesNot covered by CDC guidanceFollow with a chemical disinfectant
UV light or sunlight[2]Reduces germs in clear waterNoClear water only

Portable water filters

CDC says portable filters do not remove all types of germs:[2]

How to use one: follow the filter’s instructions. After filtering, add a chemical disinfectant such as iodine, chlorine, or chlorine dioxide to kill any viruses and bacteria.[2] When you shop, look for the “absolute” pore size on the package, not a vague claim.

Disinfection tablets and drops

Iodine: the agencies disagree

Given the disagreement, treat iodine as a last resort and keep bleach or chlorine dioxide tablets as your main chemical backup.

Distillation

Distillation removes germs that resist boiling and chlorine. It also removes heavy metals, salts, and most other chemicals.[1] Ready.gov’s method:[1]

  1. Fill a pot halfway with water.
  2. Tie a cup to the handle on the pot’s lid so the cup hangs right-side-up when the lid is upside down. Make sure the cup doesn’t dangle in the water.
  3. Boil the water for 20 minutes.
  4. The water that drips from the lid into the cup is distilled.

UV light

Portable UV units can kill germs in small amounts of clear water. They don’t work well in cloudy water. Filter or settle the water first, then follow the unit’s instructions.[2]

Solar disinfection (sunlight)

CDC says sunlight can reduce the number of germs in clear water:[2]

  1. Clear cloudy water first (filter or settle).
  2. Fill clean, clear plastic bottles with the clear water.
  3. Lay the bottles on their sides in the sun for 6 hours if it’s sunny, or 2 days if it’s cloudy. A dark surface underneath helps.

Calcium hypochlorite (pool shock): EPA only

EPA describes making a chlorine solution from high-test granular calcium hypochlorite (HTH). Add one heaping teaspoon (about ¼ ounce) to two gallons of water and stir until it dissolves. That makes roughly a 500 mg/L solution. Then add one part of this solution to each 100 parts of water you’re treating, which is about 1 pint (16 ounces) of solution to 12.5 gallons of water. Do this in a ventilated area and wear eye protection. EPA cautions that HTH is a very powerful oxidant, so follow the label for safe handling and storage.[3] Most households are better served by liquid bleach.

Sources

  1. FEMA / Ready.gov: Water
  2. CDC: How to Make Water Safe in an Emergency
  3. U.S. EPA: Emergency Disinfection of Drinking Water

Official pages checked 14 November 2026. Guidance changes; follow your local officials first. How we research.

Page checked on · Change log · Report an error · Calm by design